Recuperator accessories

  • Control panels, kitchen hoods and other materials from various manufacturers.

    Flexit control panel, CI600
    Code: CI600

    The control panels CI 60 and CI 600 are suitable for Flexit's residential unit UNI series. The units can be controlled automatically or regulated directly via the control panels. In addition, there is a lot of control equipment as accessories. Via timers, CO2, pressure and presence sensors, you can automate the ventilation, ensure a good indoor climate and low energy consumption. 

    375  VAT incl.
    Flexit control panel, CI60
    Code: CI60

    The control panels CI 60 and CI 600 are suitable for Flexit's residential unit UNI series. The units can be controlled automatically or regulated directly via the control panels. In addition, there is a lot of control equipment as accessories. Via timers, CO2, pressure and presence sensors, you can automate the ventilation, ensure a good indoor climate and low energy consumption. 

    175  VAT incl.
    Komfovent control panel C5.1
    Code: 745201511
    Intended for Verso air handling unit with C5 control system Colour touch-sensitive LED display Smart control of parameters Integrated thermometer and hygrometer Extremely thin – only 12 mm 3 ways of mounting
    229  VAT incl.
    32670  You save 9770 
    Remote control Brink Air Control (Kopija)
    Code: 310657

    Recuperator controller Brink Air Control:

    Fan speed regulation;
    Recuperator working time programming;
    Setting ventilation modes;
    Filter replacement indicator;
    Language selection;
    Fault mapping;
    Timing;
    Warranty: 2 years.

    Suitable for all BRINK Renovent recuperators. 

    19399  VAT incl.
    Zehnder recuperator module ComfoConnect KNX C
    Code: 655011120

    The Zehnder ComfoAir Q ventilation unit can be integrated with EIB/KNX building management systems. The only component required is the Zehnder ComfoConnect KNX C interface. This device establishes a connection between the Zehnder ComfoAir Q ventilation unit and the KNX building management system. In this way, the ventilation unit can be monitored and controlled using KNX devices. In addition, the device also allows you to control the main Zehnder ComfoHood kitchen hood. The device can be mounted on any wall. Zehnder ComfoConnect KNX C is connected to the ventilation unit with a 4-wire ComfoNET cable. Additional drivers or components can be added without customizing the KNX installation. Assigning addresses to the KNX integrator is much easier thanks to the dynamic address allocation of ETS 5 (not included).

    399  VAT incl.
    51038  You save 11138 
    Brink Touch Control remote control
    Code: 532743

    Brink Touch Control makes it easy and simple to adjust the settings of the ventilation unit. The intelligent Touch Control interface makes it easy to adapt to the desired ventilation settings for your home. Whether adjusting manually or using timer programming, Touch Control ensures excellent air quality in the home.

    175  VAT incl.
    20449  You save 2949 
    Mini recuperator Zehnder ComfoSpot 50 tube, L-600 mm
    Code: 527005440

    Extension tube suitable for mini recuperator Zehnder ComfoSpot 50;
    Length, mm: 600;
    Diameter, mm: 315. 

    109  VAT incl.
    13334  You save 2434 
    Control panel Zehnder ComfoSense C67
    Code: 655010235

    The Zehnder ComfoSense C67 is a four position switch designed to enable the user to manually select the desired ventilation systems flow rate and provide system notifications.

    Key Benefits:

    4 separate ventilation flow rate options to select in 1 controller 7 day flow rate programmer Summer bypass indicator Frost protection indicator Service and Maintenance alert Clock function User menu access RF bridge to enable use of the CCRFZ (655 000 755) controller 

    Suitable for recuperators: Zehnder ComfoAir Q350/450/600.

    289  VAT incl.
    38853  You save 9953 
    Mini recuperator Zehnder ComfoAir 70 tube, L-600 mm
    Code: 527005200

    Extension tube suitable for mini recuperator Zehnder ComfoAir 70;
    Length, mm: 600;
    Diameter, mm: 250. 

    8750  VAT incl.
    20570  You save 11820 
    Zehnder recuperator module ComfoConnect LAN C
    Code: ZE-Q-LAN

    ComfoConnect LAN C module for controlling the Zehnder ComfoAir Q series recuperators over the Internet by installing the ComfoConnect application on a mobile device.
    A network cable is required to connect the module to the local network. 

    259  VAT incl.
    38720  You save 12820 
    Heating pad Zehnder ComfoAir Q
    Code: ZE-Q-TEN

    Like most of the Zehnder ComfoAir Q components, this electric heating pad is also a product without analogues on the market. Thanks to the large surface area and the patented delta-shaped aluminum honeycomb, the air is heated completely and evenly, using a minimum amount of electricity. This heater is easily installed even after the recuperator has been started. 

    349  VAT incl.
    45375  You save 10475 
    Flexit control panel, NordicPanel
    Code: 119772

    NordicPanel is a control panel with a touch screen that is connected to the product with a 4-conductor cable. NordicPanel has the following functions: Adjustment, temperature adjustment, speed selection, timed forcing, home/away selection, alarm code display, alarm reset. NordicPanel is suitable for: EcoNordic and Nordic units manufactured after 1/10-2022. To easily see if the unit is compatible, there should be a cable on top of the unit labeled "NordicPanel". In some cases, you may need to update the software on the unit for the panel to work, this can be done via the FlexitGO app. It is also possible to install NordicPanel on older Nordic (not EcoNordic) units manufactured between May 2019 and September 2022, then there is a cable kit to buy, contact the nearest dealer for more info.

    Selectable functionality on the home screen; Intuitive user interface; Language neutral; Fits in standard wall mounted device box.
    209  VAT incl.
    26620  You save 5720 
    WANAS humidifier cartridge UMECTO 1300 UNI
    Code: KASETĖ WANAS UMECTO 1300 UNI

    Wanas UMECTO 1300 UNI humidifier cartridge. Easy to use. 

    Color may vary depending on the batch. 

    76  VAT incl.
    90  You save 14 
    WANAS humidifier cartridge UMECTO 600 UNI
    Code: KASETĖ WANAS UMECTO 600 UNI

    Wanas UMECTO 600 UNI humidifier cartridge. Easy to use. 

    Color may vary depending on the batch. 

    38  VAT incl.
    45  You save
    Humidifier WANAS UMECTO 1300 UNI
    Code: WANAS UMECTO 1300 UNI

    The humidifier is designed to work with all air handling units. The device is used to maintain the required humidity in the building. The action is based on the natural process of water evaporation, this process is the most beneficial for our health, and is also very energy-efficient. This solution ensures the maintenance of humidity in the building during the winter, when the humidity is low. Properly installed device does not require any maintenance apart from periodic replacement of the steam mat.

    Thanks to the new configuration, the device can be connected to any existing installation and any recuperator. The humidifier is installed on the supply air duct of the ventilation system and is an independent device. It is controlled by a controller mounted at the top, which is standard equipment of every WANAS UNI humidifier. Due to the combination with the wireless miniControl sensor, humidity control is easy and fully automatic. 

    1277  VAT incl.
    1503  You save 226 
    Humidifier WANAS UMECTO 600 UNI
    Code: WANAS UMECTO 600 UNI

    The humidifier is designed to work with all air handling units. The device is used to maintain the required humidity in the building. The action is based on the natural process of water evaporation, this process is the most beneficial for our health, and is also very energy-efficient. This solution ensures the maintenance of humidity in the building during the winter, when the humidity is low. Properly installed device does not require any maintenance apart from periodic replacement of the steam mat.

    Thanks to the new configuration, the device can be connected to any existing installation and any recuperator. The humidifier is installed on the supply air duct of the ventilation system and is an independent device. It is controlled by a controller mounted at the top, which is standard equipment of every WANAS UNI humidifier. Due to the combination with the wireless miniControl sensor, humidity control is easy and fully automatic. 

    1182  VAT incl.
    1391  You save 209 
    Ball siphon condensate drain for recuperators Renovent Sky
    Code: SKU#168501380375332381

    The siphon is designed for Renovent Sky recuperators to drain condensate into the sewer.
    The ball ensures that odors are not returned to the premises.  

    4235  - 4415  VAT incl.
    Ball siphon condensate drain for recuperators Renovent Excellent
    Code: SKU#168501146094544961

    The siphon is designed for Renovent Excellent recuperators to drain condensate into the sewer.
    The ball ensures that odors are not returned to the premises. 

    3757  - 4432  VAT incl.
    Brink Connect module (MODbus)
    Code: 532121

    The Brink Connect module is suitable for recuperators Brink Renovent Excellent 180/300/400/450 PLUS, Brink Renovent Flair 325 PLUS. 

    38115  VAT incl.
    42350  You save 4235 
    Brink Home Module
    Code: 510510

    Brink Home is an external module that can be connected to the recuperators Brink Renovent Sky and Brink Renovent Excellent. This allows remote control of the device with a smartphone, tablet or computer. It connects to the Internet via Wi-Fi or an Internet cable. 

    39857  VAT incl.
    44286  You save 4429 
    Outdoor air electric heater for recuperators Brink Renovent Excellent/Sky
    Code: SKU#168475887129056791

    Supplied air electric heater for recuperators: Brink Renovent Excellent 180, Brink Renovent Excellent 300, Brink Renovent Excellent 400, Brink Renovent Sky 150, Brink Renovent Sky 200, Brink Renovent Sky 300. 

    279  - 329  VAT incl.
    Outdoor air electric heater for recuperators Brink Renovent Flair
    Code: SKU#168475556956650491

    Supplied air electric heater for recuperators: Brink Renovent Flair 225, Brink Renovent Flair 325, Brink Renovent Flair 400, Brink Renovent Flair 450, Brink Renovent Flair 600. 

    419  - 484  VAT incl.
    Remote control Brink Air Control
    Code: 510498

    Recuperator controller Brink Air Control:

    Fan speed regulation;
    Recuperator working time programming;
    Setting ventilation modes;
    Filter replacement indicator;
    Language selection;
    Fault mapping;
    Timing;
    Warranty: 2 years.

    Suitable for all BRINK Renovent recuperators. 

    29585  VAT incl.
    Remote control panel TPC V2
    Code: ACC007602

    The TPC V2 control panel is used for the control of ventilation units with PRV2 and MCB type boards.  

    TPC V2 5m remote control panel can be used with MCB and PRV2 type control boards.

    Suitable units:

    RIS EKO 3.0 RIRS EKO 3.0 Smarty 
    99  VAT incl.
    128  You save 29 
    Smart control panel SA-CONTROL
    Code: SKU#157424461529263871

    The ST-SA-Control control panel is used for the control of ventilation units with MCB-type and PRV2 type control boards.  

    Suitable units:

    RIS EKO 3.0 RIRS EKO 3.0 Smarty AmberAir Compact AmberAir. 
    279  VAT incl.
    367  You save 88 
    Smart control panel FLEX PRV
    Code: CGU938

    The FLEX PRV control panel is used for the control of ventilation units with PRV-type boards. 

    Suitable units:

    RIS 3.0 RIRS 3.0 RIS EKO 3.0 RIRS EKO 3.0 VEKA INT EKO VEGA
    289  VAT incl.
    318  You save 29 
    Komfovent control panel C6.1
    Code: 745201581
    Intended for Domekt air handling unit with C6, C8 control system Colour touch-sensitive LED display Smart control of parameters Integrated thermometer and hygrometer Extremely thin – only 12 mm 3 ways of mounting
    229  VAT incl.
    32670  You save 9770 
    Komfovent control panel C6.2
    Code: 745201583
    Intended for Domekt air handling unit with C6, C8 control system Simple control Operation modes Touch-sensitive screen Integrated thermometer and hygrometer Extremely thin – only 12 mm 3 ways of mounting
    109  VAT incl.
    14520  You save 3620 
    Kitchen pull-out hood
    Code: 708300121

    Removes polluted air from the stove and maintains air balance indoors.
    Minimalist design.
    Painted white.
    With energy-saving LED lighting.
    It is additionally equipped with a decorative panel. 

    549  VAT incl.
    600  You save 51 
    Adapter for retractable hood
    Code: 710600269

    Suitable for ventilation units Domekt R 200 V. 

    49  VAT incl.
    Air 70 outdoor wall extension module
    Code: SKU#163031463049120101

    Suitable for mini recuperators Brink Air 70. 

    105  - 149  VAT incl.
    Air purifier Pure induct (ultra filtration)
    Code: 351000

    It will be clear that air pollution is a problem that we all have to deal with. Air pollution comes in various shapes and sizes. One of those is fine dust. Anywhere in the world where there is traffic or industry, fine dust is released. It is even in the countryside air. Fine dust consists of the very smallest particles that differ in size, origin and composition. Research shows that breathing in fine dust is harmful to health. The smaller the particles, the further they penetrate the body. With the Pure induct, Brink offers a solution that keeps these tiny particles out while your home is fully ventilated with the best and cleanest air possible. 

    1325  VAT incl.
    146894  You save 14394